RiderForums.com - Kawasaki Motorcycle Forum banner
1 - 20 of 31 Posts

· Registered
Joined
·
361 Posts
  • Like
Reactions: wingnut1000

· Registered
Joined
·
57 Posts
Anyone have the Rascal Grafiks tank pads on there N1K, hard to tell what it looks like with out a picture of them on the bike...
Anyone have pics???
 

· Registered
Joined
·
57 Posts
Naaaah... they just look big on the red Bikes lol.
 

· Registered
Joined
·
57 Posts
I think if you remove the bottom piece (or don't install it) and then install/move the pad down to the top of the seat....it could work, IMO
 

· Registered
Joined
·
361 Posts
dang that is huge!!!
 

· Registered
Joined
·
1,027 Posts
They're only huge if you're buying it for fashion. Are ya, pretty boy? :killingme

If you actually want your tank protector to protect your tank, this leaves something to be desired. The sharp edges of the tank's shape is where damage is most likely to happen, and this leaves them unprotected.
 

· Registered
Joined
·
609 Posts
Anyone know of any good tank pads? (2011 Ninja 1000) Rascal Grafiks has only 3 and they are HUGE!!
Looked into the minis but am finding a lot of junk, not large selection.

You have a preferred vendor?
Tank Slapper non-3M is pretty good - but the edges b/t the rider side of the tank and the knee locations is unprotected. And, make sure you read the instructions on the website as the tank slapper didn't come with instructions (you shouldn't put them on dry).
 

· Registered
Joined
·
242 Posts
1 - 20 of 31 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top