RiderForums.com - Kawasaki Motorcycle Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
333 Posts
Discussion Starter #2
Sorry for the poor quality of the attachment. Any suggestions on how to make this more clear are appreciated. Thanks
 

·
Wheelie for Safety
Joined
·
1,550 Posts
Hi Tom,

The picture is so bad you cannot read any of the numbers on it. Did you scan it yourself, or was it given to you on a floppy disk?

Andy
 

·
Registered
Joined
·
333 Posts
Discussion Starter #4
Andy, I scnanned it myself. It was very clear when I scanned it but I had to keep reducing the size of the file to get it below the 102,000 bit requirement for an attachment. Is there another way to post this file?
 

·
Wheelie for Safety
Joined
·
1,550 Posts
Hi Tom,

The problem is you have it in BMP format. If you save it in JPG or GIF then the file size (KB) would be much smaller.

Remember the file size must be 102 KB or less. JPG file format is the best, but GIF would also be OK.

Another thing to watch out for is the DPI. After you scan the document you should change the DPI to 72. Or just scan it at 72 DPI.

Andy
 

·
Registered
Joined
·
1,274 Posts
hey! that's one of the smoothest dyno charts i've seen for a bike! no big peaks or valleys. so maybe we don't have the most powerful bike in the work but it sure is smooth :)

scott :)
 
1 - 7 of 7 Posts
Top