RiderForums.com - Kawasaki Motorcycle Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter #1 (Edited)
This is for first gen - came from my 2003 z1000.
I have a used front set-up with banjo bolts, washers, installation pipe.
I did the 636 converson, and could not use these. These are black with silver fittings and in excellent condition.

$70 shipped anywhere in US.



 

·
Registered
Joined
·
120 Posts
Discussion Starter #3
bump...
These are a performance upgrade over stock mushy lines, you will instantly feel the firmness of the front braks as they should be....

make me an offer....
 

·
Registered
Joined
·
883 Posts
these look familiar....
 

·
Registered
Joined
·
120 Posts
Discussion Starter #8
bump...
These are a performance upgrade over stock mushy lines, you will instantly feel the firmness of the front braks as they should be....
 

·
Registered
Joined
·
1,143 Posts
If only they were for a 2nd gen. Free bump!!
 

·
Registered
Joined
·
49 Posts
What is the length???
We probably could trade if you need shorter lines as my lines are to short...I went from clip ons to bars and you went from bars to clip ons...
 

·
Registered
Joined
·
120 Posts
Discussion Starter #13
What is the length???
We probably could trade if you need shorter lines as my lines are to short...I went from clip ons to bars and you went from bars to clip ons...
Not sure about the length, these were stock size, and fit well with stock suspension and bars. I went to the 636 from froks, but still used my bars, so needed +3 inches, which I bought new.

They should fit fine on bars and stock suspension...
 
1 - 14 of 14 Posts
Top