The silver forks are off the Special Factory Paint Jobs.. You know the Silver one with the red graphics... 95% sure..

Originally Posted by CytoCycle

The silver forks are off the Special Factory Paint Jobs.. You know the Silver one with the red graphics... 95% sure..

Yep, they were on the 06 636 limited.

Originally Posted by CBR_Brutha

CALIPER BOLTS
10 x 1.25mm pitch (NOT 10 x 1.5mm)
60mm stock length, so if you're using the 10mm spacers, you'll need 70mm

AXLE PINCH BOLTS
8 x 1.25mm pitch
40mm stock length

McMaster only has 60 and 80.... where do I find 70?

McMaster has everything,usually. Can you cut the 80's down to 70's and clean up the threads?

Originally Posted by RS117

McMaster has everything,usually. Can you cut the 80's down to 70's and clean up the threads?

I could.... would rather buy them straight up, but if ness. thats what Ill do.

Yeah, I know what you mean but that would be really strightforward. I'll look through my books tomorrow at work. I have minor league softball so I won't be home till after 9 but I let you know if I find something.

Appreciate it!

Well I Got it all done, The Z handles like a totaly diferent and better by far Animal. Thanks for everyones input and answers to dumb questions.

OK..silly wabbit ???

I know all of thsi si moddd to z1000 and z750, but what about the Z750S?

can a rear fork, shock, front forks and all calipers and rotors be put on the z750s with such little problems. or of such ease?

thansk in advance....if not ill havea lot of 06 636 parts lying around i got off a buddies wrecked bike. well not wrecked blown up! and im gettinmg teh bike for all the upgrades.

THANSK IN ADVANCE!

I think the rear shock is a bolt in, but for the forks you are going to need z1k triple clamps and either a 636 / z1k front wheel or have a custom axle machined...

sweet, thanks for the info... i should have the front wheel of the 636, 06.

what about the rear fork? i can get the rear wheel as well. thanks again...

rear fork??? you mean the swing arm?? I believe you need custom spacers and a 636 wheel, there is a image floating around some where that has the dimensions for the spacers.

LMAO...yea i meant swingarm. it was to early for me... but thanks again, much appricated!

hi, i am building a custom streetfighter, , using a 2000zx6r frame to begin with. i would like to use the inverted forks from the 03-04 zx6r or 05-06 models, but i would like to have a z1000 upper triple clamp to mount the handlebar instead of the clipons. my one andonly question is can i use the z1000 upper triple clamp with the 03-04 lower triple clamp? do these two line up correctly, or should i use the z1000 upper triple clamp with the 05-06 lower triple tree? any help would be greatly appreciated.

will a 05/06 frount end fit?