RiderForums.com - Kawasaki Motorcycle Forum banner

QUESTION FOR THOSE WITH THE NOMAD FORWARD CONTROLS

1K views 2 replies 3 participants last post by  speedracer 
#1 ·
I PURCHASED A SET RECENTLY AND AM GOING TO INSTALL THEM SHORTLY BUT I NOTICED ON THE BRAKE SIDE THAT WHERE THE BOLTS FROM THE FACTORY PEG BRACKETS GO THRU THAT THE BRAKE SIDE HAS A GOOD 1/2 TO 3/4 INCH THICK SPACER WHEN THE BOLTS ARE IN THERE IS ONLY ABOUT A HALF INCH GOING INTO THE FRAME TO BOLT UP ,,,, ANY OTHERS HAD AN ISSUE WITH THIS OR NOTICED IT OR HAD A PROBLEM
 
#2 ·
I changed to Nomad Brake pedal to ficilitate the installation of my Nomad floor boards. I had no issues. The spacers that you refer to are actualy welded to the frame. And the bolt holes are blind. So you do need the correct length bolts. I was concerned with this issue also when I did my mod. So I purchased the bolts indicated on the parts fiche for the Nomad frame. Turns out that they were exactly the same bolts.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top